OK I have a bunch of graded cards that I’m tempted to bust out of the slabs to shove them into binders. However, some of my cards are really, really thick (thicc). I know there are binders now for top-loaders (I was looking at this).
Here’s an example comparison:
Also, I imagine even if I can get this to fit- I’d probably hafta place standard cards opposite side on the same sleeve?
Another layer to this- can these pages handle the thicc cards inside of a magnetic case?
OK so I bought this slab binder from Amazon.
I also bought magnetic holder cases. Two examples:
The one on the left is 130pt, on the right is 360pt (I’ve never seen anything that thicc before)
Here’s a thiccness comparison with a Pokemon card inside of a semi-rigid:
Here’s how the binder looks:
Since this binder is designed for standard TCG PSA slabs, anything taller won’t work. The magnetic holder fit decently, but because they’re fatter you see that they move off-center a bit. The 360pt fits, too.
I placed a PSA-slabbed Pokemon card + a BGS standard slab to show the fit. BGS is roughly as tall but thiccer than PSA so they simply don’t fit. Also, PSA slabs any thiccer than your standard Pokemon, Magic, Yu-Gi-Oh, etc. wouldn’t fit because the sleeves just tall enough that a standard PSA slab fits firmly. An example of this would be a jersey card slabbed by PSA. CGC standard slabs fit well, too. If you have the slab wrapped in its own sleeve it might not fit right. Note that Reflecto (all praise!) is sleeved but just barely fits in its slot.
Thank goodness reflecto fits!!!
Glad you found a solution!!
